PlayStation, Repair Service

How to Replace a DualShock 4 Ribbon Cable

DualShock 4 Ribbon Cable Replacement

Introduction: You’ve probably been using a DualShock 4 for years now, but it’s time to think about upgrading. After all, those cords are becoming tired and old. And if you don’t want to spend a fortune on a new cable, you might be in luck. In this article, we’ll take a look at what you need to replace your DualShock 4 ribbon cable and see how much money you can save.

How to Replace a DualShock 4 Ribbon Cable.

The DualShock 4 ribbon cable is a cable used to connect the controller to the computer. It consists of two strands of wire, one red and one green, that are twisted together. The red and green wires are connected to each other at one end while the other end is connected to the computer.

To replace a DualShock 4 ribbon cable, you will first need to identify which strand of wire is the original ribbon cable and which strand has been replaced. If you are replacing a dualshock 4 ribbon cable that has been lost or damaged, be sure to take apart your controller so you can determine which strand of wire was used in connection with the old ribbon cable. Once you have determined which strand of wire was used in connection with the old Ribbon Cable, you will need to cut it off from the rest of the cables and replace it with the new DualShock 4 ribbon cable.

To find your closest store

Leave your mobile phone number and we will call you back
Please enable JavaScript in your browser to complete this form.
Select what you want

How to replace a DualShock 4 Ribbon Cable.

To replace aDualShock 4 ribbon cable, follow these steps:1) Remove all screws from behind the motherboard where it attaches to your computer (this includes both sides). 2) Disconnect all cables from your controller 3) Locate and remove any chips or connectors that may be attached to either side of your controller4) Cut off both ends of the originalDualShock 4 ribbonscable5) Connect new DualShock 4 ribbonscable toocomputer6) Reattach all screws on motherboard and connect to controller

How to Replace a DualShock 4 Cable.

Remove the old ribbon cable by cutting it in half with a sharp knife.

Attach the new ribbon cable to the end of the old DualShock 4 cable.

Reattach the oldDualShock 4 Ribbon Cable by screwing it back into place.

How to Replace a DualShock 4 Cable.

To remove the old cable, first detach the power cord from the DualShock 4.

Cut the old cable in half with a scissors so that each half is long enough to be inserted into the new DualShock 4 Cable.

Attach the two halves of the cable together using pliers or your fingers.

Reattach the power cord to the DualShock 4 and enjoy your newDualShock 4 Cable!


Replacing a DualShock 4 cable can be a very simple and straightforward task. By removing the old cable and putting the new one in place, you should be able to reconnect your DualShock 4 and play your games with ease. If everything goes according to plan, you should be able to finish up the replacement process in no time.

Your Repair , Our Concern-  Leave your mobile phone number and we will call you back . Consolefixit are experts at fixing game consoles. If your Xbox, PlayStation, or Nintendo is broken and needs repairing, give us a call for a free quote today.

Related Posts